P1339 – Audi DTC

Audi DTC P1339 – Crankshaft Position/Engine Speed Sensor Cross Connected

DTC P1339 meaning on Audi

DTC P1339 on an Audi indicates a fault with the Crankshaft Position/Engine Speed Sensor being cross connected. This means that the signal from the sensor is not being received correctly by the Engine Control Module (ECM), leading to potential issues with engine performance and drivability.

Audi DTC P1339 symptoms

Symptoms of DTC P1339 on an Audi may include:

• Engine misfires
• Rough idling
• Loss of power
• Stalling
• Check Engine Light (MIL) illuminated

Audi DTC P1339 causes

The common causes of DTC P1339 on an Audi are:

• Faulty Crankshaft Position/Engine Speed Sensor
• Wiring issues or poor connections
• ECM software or hardware problems

Audi DTC P1339 seriousness

DTC P1339 should not be ignored as it can lead to potential engine performance issues and drivability problems. Ignoring this fault may result in further damage to engine components.

How to diagnose DTC P1339 on Audi

To diagnose DTC P1339 on an Audi, follow these steps:

1. Use a diagnostic scanner to retrieve the fault codes.
2. Inspect the Crankshaft Position/Engine Speed Sensor and its wiring for any visible damage.
3. Check the sensor’s signal using a multimeter to ensure it is within specifications.
4. Perform a visual inspection of the ECM connectors and wiring for any signs of corrosion or damage.

How to fix DTC P1339 on Audi

To fix DTC P1339 on an Audi, you can:

1. Replace the faulty Crankshaft Position/Engine Speed Sensor.
2. Repair any damaged wiring or connectors related to the sensor.
3. Update the ECM software if necessary.

How to erase DTC P1339 on Audi

To erase DTC P1339 on an Audi:

1. Use a diagnostic scanner to clear the fault codes.
2. After fixing the underlying issue, drive the vehicle to allow the ECM to relearn the sensor signals.
3. Ensure the Check Engine Light (MIL) does not reappear after clearing the fault code.