P1374 – Audi DTC

Audi DTC P1374 – Cylinder 7, ignition circuit Short Circuit to B+

DTC P1374 meaning on Audi

DTC P1374 on an Audi indicates a short circuit to B+ in the ignition circuit of cylinder 7. This fault code is specific to the ignition system of the vehicle and points towards an electrical issue in the circuit related to the ignition coil or wiring for cylinder 7.

Audi DTC P1374 symptoms

Symptoms of DTC P1374 on an Audi may include:

• Check Engine Light illuminated on the dashboard
• Engine misfires or runs rough
• Reduced engine performance
• In some cases, the vehicle may not start

Audi DTC P1374 causes

The common causes of DTC P1374 on an Audi are:

• Short circuit to B+ in the ignition circuit for cylinder 7
• Faulty ignition coil for cylinder 7
• Wiring issues such as damaged or corroded wires
• ECU (Engine Control Unit) malfunction

Audi DTC P1374 seriousness

DTC P1374 should be addressed promptly as it can lead to engine performance issues and potential damage if left unresolved. Ignition system problems can cause misfires, which can result in increased emissions, reduced fuel efficiency, and even engine damage over time.

How to diagnose DTC P1374 on Audi

To diagnose DTC P1374 on an Audi, follow these steps:

1. Use an OBD-II scanner to retrieve the fault code and verify it is P1374.
2. Inspect the wiring harness and connectors related to the ignition system for cylinder 7.
3. Check the ignition coil for cylinder 7 for any signs of damage or malfunction.
4. Perform a continuity test on the wiring to identify any short circuits to B+.
5. If necessary, test the ECU for proper operation.

How to fix DTC P1374 on Audi

To fix DTC P1374 on an Audi, consider the following steps:

1. Repair any damaged or corroded wiring in the ignition circuit for cylinder 7.
2. Replace the ignition coil for cylinder 7 if it is faulty.
3. If a short circuit is detected, isolate and repair the issue.
4. If the ECU is found to be faulty, consider replacing or reprogramming it.

How to erase DTC P1374 on Audi

After fixing the underlying issue causing DTC P1374 on an Audi, you can erase the fault code using an OBD-II scanner. Follow these steps:

1. Connect the OBD-II scanner to the vehicle’s diagnostic port.
2. Access the scanner’s menu to clear the fault codes stored in the ECU.
3. Follow the on-screen prompts to erase the DTC P1374 code.
4. Once the code is cleared, start the vehicle and ensure the Check Engine Light does not reappear.

Recommended tools for Audi diagnostics

Explore our expert picks: The Best OBD2 Scanners for 2025

Easy-to-use Multimeter for reliable diagnostics: AstroAI Auto-ranging Multimeter

Some of the links on this page may be affiliate links, which means we may earn a small commission if you make a purchase. This helps us keep our DTC database up to date and provide valuable content for free. We only recommend products that we have tested and believe to be the best in their class.