P1436 – Audi DTC

Audi DTC P1436 – Secondary Air Injection SystemPump Relay Circuit Electrical Malfunction

DTC P1436 meaning on Audi

DTC P1436 on an Audi indicates a Secondary Air Injection System Pump Relay Circuit Electrical Malfunction. This fault code is triggered when the Engine Control Module (ECM) detects an issue with the electrical circuit of the secondary air injection system pump relay.

Audi DTC P1436 symptoms

Symptoms of DTC P1436 in an Audi may include:

• Check Engine Light (MIL) illuminated on the dashboard
• Reduced engine performance
• In some cases, the vehicle may go into a limp mode

Audi DTC P1436 causes

The common causes of DTC P1436 in an Audi are:

• Faulty secondary air injection system pump relay
• Wiring issues in the relay circuit
• Defective Engine Control Module (ECM)

Audi DTC P1436 seriousness

While DTC P1436 may not cause immediate drivability issues, it is important to address this fault code promptly. Ignoring this fault can lead to increased emissions, reduced fuel efficiency, and potential long-term damage to the vehicle’s emissions control system.

How to diagnose DTC P1436 on Audi

To diagnose DTC P1436 on an Audi, a mechanic would typically perform the following steps:

1. Use a diagnostic scanner to retrieve the fault code and related data
2. Inspect the secondary air injection system pump relay and associated wiring for any visible damage
3. Test the relay and circuit for proper voltage and continuity
4. Check the ECM for any stored codes or issues

How to fix DTC P1436 on Audi

To fix DTC P1436 on an Audi, the following steps are commonly taken:

1. Replace the faulty secondary air injection system pump relay
2. Repair any damaged wiring in the relay circuit
3. If necessary, replace the Engine Control Module (ECM)
4. Clear the fault code and perform a test drive to ensure the issue is resolved

How to erase DTC P1436 on Audi

To erase DTC P1436 on an Audi, the fault code can be cleared using a diagnostic scanner. After the repair has been completed, the mechanic can use the scanner to clear the code from the ECM’s memory. It is important to ensure that the underlying issue causing the fault code has been resolved before clearing it.