P1457 – Audi DTC

Audi DTC P1457 – Exhaust gas temperature sensor 2 open/short to B+

DTC P1457 meaning on Audi

The Diagnostic Trouble Code (DTC) P1457 for Audi indicates an issue with the Exhaust Gas Temperature Sensor 2, specifically an open or short circuit to B+ (positive battery voltage). This fault code is related to the sensor that monitors the exhaust gas temperature in the vehicle’s exhaust system.

Audi DTC P1457 symptoms

Symptoms of DTC P1457 on an Audi may include:

• Check Engine Light (MIL) illuminated on the dashboard
• Reduced engine performance
• Potential increase in fuel consumption

Audi DTC P1457 causes

Common causes of DTC P1457 on an Audi include:

• Exhaust Gas Temperature Sensor 2 failure
• Wiring issues such as open circuits or short circuits to B+
• Faulty connections or poor electrical connections

Audi DTC P1457 seriousness

While DTC P1457 may not cause immediate drivability issues, it is important to address this fault code promptly to prevent potential long-term damage to the vehicle’s emissions system and ensure optimal engine performance.

How to diagnose DTC P1457 on Audi

To diagnose DTC P1457 on an Audi, follow these steps:

1. Use an OBD-II scanner to retrieve the specific fault code and freeze frame data.
2. Inspect the Exhaust Gas Temperature Sensor 2 and its wiring for any visible damage or corrosion.
3. Perform a continuity test on the sensor and its wiring to check for open or short circuits.
4. Check the sensor’s resistance values to determine if it is within the manufacturer’s specifications.

How to fix DTC P1457 on Audi

To fix DTC P1457 on an Audi, consider the following steps:

1. Replace the Exhaust Gas Temperature Sensor 2 if it is found to be faulty.
2. Repair any damaged wiring or connections associated with the sensor.
3. Clear the fault code using an OBD-II scanner after completing the repairs.
4. Perform a test drive to ensure the issue has been resolved and the Check Engine Light does not reappear.

How to erase DTC P1457 on Audi

To erase DTC P1457 on an Audi:

1. Connect an OBD-II scanner to the vehicle’s diagnostic port.
2. Access the scanner’s menu to clear the fault codes stored in the vehicle’s ECU.
3. Follow the on-screen prompts to erase the DTC P1457 code.
4. Once the code is cleared, disconnect the scanner and start the vehicle to ensure the Check Engine Light is no longer illuminated.

Recommended tools for Audi diagnostics

Explore our expert picks: The Best OBD2 Scanners for 2025

Easy-to-use Multimeter for reliable diagnostics: AstroAI Auto-ranging Multimeter

Some of the links on this page may be affiliate links, which means we may earn a small commission if you make a purchase. This helps us keep our DTC database up to date and provide valuable content for free. We only recommend products that we have tested and believe to be the best in their class.