P1466 – Audi DTC

Audi DTC P1466 – Additive Pump Open/Short to Ground

DTC P1466 meaning on Audi

DTC P1466 on an Audi indicates a fault with the additive pump circuit, specifically an open or short to ground. The additive pump is responsible for injecting AdBlue (diesel exhaust fluid) into the exhaust system to reduce emissions. When this fault code is triggered, it means that the Engine Control Module (ECM) has detected an issue with the electrical circuit of the additive pump.

Audi DTC P1466 symptoms

Symptoms of DTC P1466 on an Audi may include:

• Check Engine Light illuminated
• Reduced engine performance
• Increased emissions
• AdBlue warning light on the dashboard

Audi DTC P1466 causes

The common causes of DTC P1466 on an Audi are:

• Open or short to ground in the wiring harness of the additive pump
• Defective additive pump
• Faulty Engine Control Module (ECM)

Audi DTC P1466 seriousness

DTC P1466 should not be ignored as it can lead to increased emissions and potential engine performance issues. It is important to address this fault code promptly to ensure proper functioning of the emissions control system in the vehicle.

How to diagnose DTC P1466 on Audi

To diagnose DTC P1466 on an Audi, follow these steps:

1. Use a diagnostic scanner to retrieve the fault code and freeze frame data
2. Inspect the wiring harness of the additive pump for any visible damage or corrosion
3. Test the continuity of the wiring and check for any shorts to ground
4. Check the operation of the additive pump using a scan tool
5. If necessary, perform a resistance test on the pump to determine its condition

How to fix DTC P1466 on Audi

To fix DTC P1466 on an Audi, consider the following steps:

1. Repair any damaged wiring or connectors in the additive pump circuit
2. Replace the additive pump if it is found to be faulty
3. If the ECM is suspected to be the issue, have it tested and replaced if necessary
4. Clear the fault code and perform a test drive to ensure the issue has been resolved

How to erase DTC P1466 on Audi

To erase DTC P1466 on an Audi, you can use a diagnostic scanner to clear the fault code from the ECM’s memory. After the repair has been completed and the issue resolved, clearing the fault code will reset the Check Engine Light and ensure that the system is functioning properly.

Recommended tools for Audi diagnostics

Explore our expert picks: The Best OBD2 Scanners for 2025

Easy-to-use Multimeter for reliable diagnostics: AstroAI Auto-ranging Multimeter

Some of the links on this page may be affiliate links, which means we may earn a small commission if you make a purchase. This helps us keep our DTC database up to date and provide valuable content for free. We only recommend products that we have tested and believe to be the best in their class.