P1605 – Audi DTC

Audi DTC P1605 – Rough Road/Acceleration Sensor Electrical Malfunction

DTC P1605 meaning on Audi

The Diagnostic Trouble Code (DTC) P1605 for Audi refers to a Rough Road/Acceleration Sensor Electrical Malfunction. This code indicates that there is an issue with the electrical circuit of the rough road sensor or acceleration sensor in the vehicle.

Audi DTC P1605 symptoms

Symptoms of DTC P1605 on an Audi may include:

• Check Engine Light illuminated on the dashboard
• Reduced engine performance
• Unusual or rough driving experience
• In some cases, the vehicle may go into a limp mode

Audi DTC P1605 causes

The common causes of DTC P1605 on an Audi include:

• Faulty rough road sensor or acceleration sensor
• Wiring or connector issues in the sensor circuit
• Corrosion or damage to sensor components
• Electronic control module (ECM) malfunction

Audi DTC P1605 seriousness

While DTC P1605 may not always result in immediate drivability issues, it is important to address this code promptly. Ignoring this fault can lead to further damage to the vehicle’s systems and potentially compromise safety and performance.

How to diagnose DTC P1605 on Audi

To diagnose DTC P1605 on an Audi, a mechanic would typically perform the following steps:

1. Use a diagnostic scanner to retrieve the fault codes stored in the vehicle’s ECM
2. Inspect the rough road sensor and acceleration sensor for any visible damage or corrosion
3. Check the wiring and connectors associated with the sensors for loose connections or breaks
4. Perform a circuit test to ensure proper electrical continuity
5. If necessary, test the sensor outputs using a multimeter

How to fix DTC P1605 on Audi

To fix DTC P1605 on an Audi, the following steps may be taken:

1. Replace the faulty rough road sensor or acceleration sensor
2. Repair or replace any damaged wiring or connectors in the sensor circuit
3. Clean or replace sensor components affected by corrosion
4. If the ECM is determined to be faulty, it may need to be reprogrammed or replaced

How to erase DTC P1605 on Audi

To erase DTC P1605 on an Audi, the fault code can be cleared using a diagnostic scanner. After the necessary repairs have been made to address the underlying issue causing the fault code, the scanner can be used to clear the code from the ECM’s memory. This will reset the Check Engine Light and allow for a fresh start in monitoring the vehicle’s systems.

Recommended tools for Audi diagnostics

Explore our expert picks: The Best OBD2 Scanners for 2025

Easy-to-use Multimeter for reliable diagnostics: AstroAI Auto-ranging Multimeter

Some of the links on this page may be affiliate links, which means we may earn a small commission if you make a purchase. This helps us keep our DTC database up to date and provide valuable content for free. We only recommend products that we have tested and believe to be the best in their class.