P2607 – Audi DTC

Audi DTC P2607 – Intake air heater, Powertrain Control Module (PCM) failure, Wiring issue

DTC P2607 meaning on Audi

DTC P2607 refers to a problem with the intake air heater circuit in Audi vehicles. This code indicates that the Powertrain Control Module (PCM) has detected a malfunction in the intake air heater system. The intake air heater is responsible for warming the air entering the engine, which can improve cold start performance and reduce emissions. A failure in this system can lead to poor engine performance and increased emissions.

Audi DTC P2607 symptoms

Common symptoms associated with DTC P2607 may include:

• Check Engine Light illuminated
• Difficulty starting the engine, especially in cold weather
• Rough idling or stalling
• Increased exhaust emissions
• Reduced engine performance

Audi DTC P2607 causes

Several factors can lead to the triggering of DTC P2607, including:

• Faulty intake air heater element
• Defective Powertrain Control Module (PCM)
• Wiring issues, such as damaged or corroded connectors
• Short circuits or open circuits in the intake air heater circuit
• Faulty relays or fuses related to the intake air heater

Audi DTC P2607 seriousness

DTC P2607 is considered a moderate to serious issue. While it may not cause immediate engine failure, it can lead to:

• Increased emissions, which can affect compliance with environmental regulations
• Poor engine performance, leading to drivability issues
• Potential long-term damage to the engine if not addressed

How to diagnose DTC P2607 on Audi

To diagnose DTC P2607, follow these steps:

1. Use an OBD-II scanner to confirm the presence of DTC P2607.
2. Inspect the intake air heater circuit for visible damage or corrosion.
3. Check the wiring and connectors for continuity and proper voltage.
4. Test the intake air heater element for resistance using a multimeter.
5. Examine the PCM for any signs of failure or damage.
6. Clear the DTC and perform a road test to see if the code returns.

How to fix DTC P2607 on Audi step-by-step instructions

To fix DTC P2607, follow these steps:

1. Diagnose the issue as outlined above.
2. If the intake air heater element is faulty, replace it with a new one.
3. Repair or replace any damaged wiring or connectors in the intake air heater circuit.
4. If the PCM is defective, consider reprogramming or replacing it.
5. Replace any faulty relays or fuses associated with the intake air heater.
6. Clear the DTC using an OBD-II scanner.
7. Test drive the vehicle to ensure the issue is resolved and the code does not return.

How to erase DTC P2607 on Audi

To erase DTC P2607, follow these steps:

1. Connect an OBD-II scanner to the vehicle’s diagnostic port.
2. Turn on the ignition without starting the engine.
3. Access the diagnostic menu on the scanner.
4. Select the option to clear or erase trouble codes.
5. Confirm the action and wait for the scanner to complete the process.
6. Disconnect the scanner and start the engine to verify that the code does not return.