P007E – BMW DTC

BMW DTC P007E – Charge Air Cooler Temperature Sensor Circuit Intermittent/Erratic (Bank 1)

DTC P007E meaning on BMW

The Diagnostic Trouble Code (DTC) P007E for BMW refers to the Charge Air Cooler Temperature Sensor Circuit being intermittent or erratic on Bank 1. This code indicates that there is a malfunction or inconsistency in the circuit responsible for monitoring the temperature of the charge air cooler in the engine.

BMW DTC P007E symptoms

Symptoms of the BMW DTC P007E may include:

  • Check Engine Light (CEL) illuminated on the dashboard
  • Reduced engine performance
  • Decreased fuel efficiency
  • Engine overheating

BMW DTC P007E causes

Common causes of the BMW DTC P007E may include:

  • Faulty charge air cooler temperature sensor
  • Wiring or connector issues in the sensor circuit
  • Intermittent electrical connection problems
  • Software or calibration issues

BMW DTC P007E seriousness

The BMW DTC P007E should not be ignored as it can lead to potential engine performance issues and reduced efficiency. Ignoring this code may result in further damage to the engine components over time.

How to diagnose DTC P007E on BMW

To diagnose the DTC P007E on a BMW, a mechanic would typically perform the following steps:

  1. Use a diagnostic scanner to retrieve the fault codes
  2. Inspect the charge air cooler temperature sensor and its wiring for any visible damage
  3. Test the sensor’s resistance and voltage readings
  4. Check for any loose or corroded connections in the circuit

How to fix DTC P007E on BMW

To fix the DTC P007E on a BMW, the following steps may be taken:

  1. Replace the faulty charge air cooler temperature sensor
  2. Repair or replace any damaged wiring or connectors in the sensor circuit
  3. Clear the fault codes and reset the Check Engine Light
  4. Perform a test drive to ensure the issue has been resolved

How to erase DTC P007E on BMW

To erase the DTC P007E on a BMW, the fault codes can be cleared using a diagnostic scanner. After fixing the underlying issue causing the code, the scanner can be used to reset the codes and turn off the Check Engine Light.