P00EE – BMW DTC

BMW DTC P00EE – Intake Air Temperature Sensor 3 Circuit Range/Performance (Bank 2)

DTC P00EE meaning on BMW

The DTC P00EE error code on a BMW indicates an issue with the Intake Air Temperature Sensor 3 Circuit Range/Performance in Bank 2. This means that the Engine Control Module (ECM) has detected a problem with the intake air temperature sensor’s signal in the specified bank.

BMW DTC P00EE symptoms

Symptoms of the DTC P00EE error code on a BMW may include:

• Check Engine Light (CEL) illuminated on the dashboard
• Reduced engine performance or power
• Poor fuel efficiency
• Engine stalling or rough idling

BMW DTC P00EE causes

Common causes of the DTC P00EE error code on a BMW include:

• Faulty intake air temperature sensor
• Wiring or connector issues in the intake air temperature sensor circuit
• ECM software or hardware problems

BMW DTC P00EE seriousness

The DTC P00EE error code should not be ignored as it can lead to poor engine performance, reduced fuel efficiency, and potential drivability issues. It is recommended to address this issue promptly to prevent further damage to the vehicle.

How to diagnose DTC P00EE on BMW

To diagnose the DTC P00EE error code on a BMW, you can follow these steps:

1. Use an OBD-II scanner to retrieve the specific fault code
2. Inspect the intake air temperature sensor and its wiring for any visible damage or corrosion
3. Check the sensor’s resistance and voltage values using a multimeter
4. Perform a visual inspection of the ECM connectors and wiring for any signs of damage

How to fix DTC P00EE on BMW

To fix the DTC P00EE error code on a BMW, you can try the following solutions:

1. Replace the faulty intake air temperature sensor
2. Repair or replace any damaged wiring or connectors in the sensor circuit
3. Clear the fault code and reset the ECM by disconnecting the battery for a few minutes
4. If the issue persists, seek professional help for further diagnosis and repair

How to erase DTC P00EE on BMW

To erase the DTC P00EE error code on a BMW, you can:

1. Use an OBD-II scanner to clear the fault code
2. Disconnect the battery for a few minutes to reset the ECM
3. After performing the necessary repairs, clear the fault code and monitor the system for any recurring issues

Recommended tools & DTC Scanners for BMW

Best Diagnostic App for modern BMWs: BimmerLink

Recommended Bluetooth adapter for Bimmerlink: OBDLink CX

Cable adapter for Bimmerlink: Enet Cable USB Type C

For older BMWs we recommend: Autel AutoLink AL319 (2024 version)

Easy-to-use Multimeter for reliable diagnostics: AstroAI Auto-ranging Multimeter

Some of the links on this page may be affiliate links, which means we may earn a small commission if you make a purchase. This helps us keep our DTC database up to date and provide valuable content for free. We only recommend products that we have tested and believe to be the best in their class.