P0341 – BMW DTC

BMW DTC P0341 – Camshaft Position Sensor ‘A’ Circuit Range/Performance (Bank 1 or Single Sensor)

DTC P0341 meaning on BMW

The Diagnostic Trouble Code (DTC) P0341 for BMW indicates a fault with the Camshaft Position Sensor ‘A’ Circuit Range/Performance on Bank 1 or a single sensor. This code is triggered when the engine control module (ECM) detects that the camshaft position sensor signal is out of range or not performing within the expected parameters.

BMW DTC P0341 symptoms

Symptoms of a DTC P0341 on a BMW may include:

• Check Engine Light (CEL) illuminated on the dashboard
• Engine misfires or runs rough
• Poor engine performance
• Difficulty starting the engine
• Engine stalling

BMW DTC P0341 causes

Common causes of a DTC P0341 on a BMW include:

• Defective camshaft position sensor
• Wiring or connector issues in the camshaft position sensor circuit
• Timing chain or belt problems
• ECM software issues

BMW DTC P0341 seriousness

While a DTC P0341 may not always result in immediate engine failure, it is important to address this issue promptly. Ignoring this code can lead to poor engine performance, reduced fuel efficiency, and potential damage to other engine components over time.

How to diagnose DTC P0341 on BMW

To diagnose a DTC P0341 on a BMW, you can perform the following steps:

1. Use a diagnostic scanner to retrieve the fault code and any related freeze frame data
2. Inspect the camshaft position sensor and its wiring for any visible damage or corrosion
3. Check the timing chain or belt for proper alignment and tension
4. Test the camshaft position sensor using a multimeter to ensure it is functioning correctly

How to fix DTC P0341 on BMW

To fix a DTC P0341 on a BMW, you can try the following solutions:

1. Replace the camshaft position sensor if it is found to be faulty
2. Repair any damaged wiring or connectors in the camshaft position sensor circuit
3. Ensure the timing chain or belt is properly aligned and tensioned
4. If necessary, update the ECM software to address any programming issues

How to erase DTC P0341 on BMW

To erase a DTC P0341 on a BMW, you can use a diagnostic scanner to clear the fault code from the ECM’s memory. After addressing the underlying issue that caused the code, clearing the code will reset the Check Engine Light and allow you to monitor the system for any recurring problems.

Recommended tools & DTC Scanners for BMW

Best Diagnostic App for modern BMWs: BimmerLink

Recommended Bluetooth adapter for Bimmerlink: OBDLink CX

Cable adapter for Bimmerlink: Enet Cable USB Type C

For older BMWs we recommend: Autel AutoLink AL319 (2024 version)

Easy-to-use Multimeter for reliable diagnostics: AstroAI Auto-ranging Multimeter

Some of the links on this page may be affiliate links, which means we may earn a small commission if you make a purchase. This helps us keep our DTC database up to date and provide valuable content for free. We only recommend products that we have tested and believe to be the best in their class.