P072E – BMW DTC

BMW DTC P072E – Stuck in Gear 3

DTC P072E meaning on BMW

The DTC P072E code on a BMW indicates that the transmission control module has detected that the vehicle is stuck in gear 3. This means that the transmission is not shifting properly and is remaining in third gear even when it should be shifting to a different gear.

BMW DTC P072E symptoms

Symptoms of the DTC P072E code on a BMW may include:

• Engine revving higher than normal
• Sluggish acceleration
• Difficulty shifting gears
• Check Engine Light illuminated

BMW DTC P072E causes

The DTC P072E code on a BMW can be caused by various factors, including:

• Low transmission fluid level
• Transmission fluid contamination
• Malfunctioning transmission control module
• Faulty shift solenoid

BMW DTC P072E seriousness

Ignoring the DTC P072E code on a BMW can lead to further transmission damage and potential safety hazards. It is important to address this issue promptly to prevent more severe problems and ensure the vehicle operates safely.

How to diagnose DTC P072E on BMW

To diagnose the DTC P072E code on a BMW, a mechanic may perform the following steps:

1. Use a diagnostic scanner to retrieve the fault codes
2. Inspect the transmission fluid level and condition
3. Check for any visible leaks or damage to the transmission components
4. Test the transmission control module and shift solenoids for proper function

How to fix DTC P072E on BMW

To fix the DTC P072E code on a BMW, the following steps may be taken:

1. Top up or replace the transmission fluid if low or contaminated
2. Repair or replace any damaged transmission components
3. Replace the faulty shift solenoid if necessary
4. Reset the transmission control module and perform a test drive to ensure proper shifting

How to erase DTC P072E on BMW

After fixing the underlying issue causing the DTC P072E code on a BMW, the code can be erased using a diagnostic scanner. This will clear the code from the vehicle’s memory and turn off the Check Engine Light. It is important to ensure that the issue has been resolved before clearing the code.