BMW DTC P10D4 – Cold Start Engine Coolant Temperature Too Low
DTC P10D4 meaning on BMW
The DTC P10D4 fault code on BMW vehicles indicates that the engine control module (ECM) has detected that the engine coolant temperature during cold start is too low. This means that the engine coolant temperature is below the expected threshold when the engine is started from a cold condition.
BMW DTC P10D4 symptoms
Some common symptoms associated with the BMW DTC P10D4 fault code may include:
- Extended engine warm-up time
- Poor fuel economy
- Decreased engine performance
- Check Engine Light (CEL) illuminated on the dashboard
BMW DTC P10D4 causes
The potential causes of the BMW DTC P10D4 fault code include:
- Malfunctioning engine coolant temperature sensor
- Issues with the thermostat
- Low coolant level
- Wiring or connector problems in the coolant temperature sensor circuit
BMW DTC P10D4 seriousness
While the BMW DTC P10D4 fault code may not cause immediate drivability issues, it is important to address the underlying problem to prevent potential long-term damage to the engine and ensure optimal performance and fuel efficiency.
How to diagnose DTC P10D4 on BMW
To diagnose the DTC P10D4 fault code on a BMW, a mechanic may perform the following steps:
- Use a diagnostic scanner to retrieve the fault code and freeze frame data
- Inspect the engine coolant temperature sensor and its wiring for any visible damage
- Check the coolant level and condition
- Test the thermostat for proper operation
How to fix DTC P10D4 on BMW
Depending on the root cause of the BMW DTC P10D4 fault code, the following steps may be taken to fix the issue:
- Replace the faulty engine coolant temperature sensor
- Repair or replace any damaged wiring or connectors in the sensor circuit
- Ensure the coolant level is at the proper level and the coolant is in good condition
- Replace the thermostat if found to be faulty
How to erase DTC P10D4 on BMW
After addressing the underlying issue causing the DTC P10D4 fault code on a BMW, the fault code can be cleared using a diagnostic scanner. This will reset the Check Engine Light and allow the vehicle’s ECM to monitor the system for any new faults.
Recommended tools & DTC Scanners for BMW
Best Diagnostic App for modern BMWs: BimmerLink
Recommended Bluetooth adapter for Bimmerlink: OBDLink CX
Cable adapter for Bimmerlink: Enet Cable USB Type C
For older BMWs we recommend: Autel AutoLink AL319 (2024 version)
Easy-to-use Multimeter for reliable diagnostics: AstroAI Auto-ranging Multimeter
Some of the links on this page may be affiliate links, which means we may earn a small commission if you make a purchase. This helps us keep our DTC database up to date and provide valuable content for free. We only recommend products that we have tested and believe to be the best in their class.