BMW DTC P1583 – Engine Oil Pump Control Circuit Low
DTC P1583 meaning on BMW
DTC P1583 on a BMW indicates a fault in the engine oil pump control circuit. This fault code is triggered when the engine control module (ECM) detects that the voltage signal from the oil pump control circuit is lower than the specified threshold.
BMW DTC P1583 symptoms
Symptoms of DTC P1583 on a BMW may include:
- Check Engine Light (CEL) illuminated on the dashboard
- Engine running rough or misfiring
- Loss of power or acceleration
- Engine stalling or not starting
BMW DTC P1583 causes
The common causes of DTC P1583 on a BMW include:
- Faulty engine oil pump control module
- Wiring issues in the oil pump control circuit
- Low engine oil level or pressure
- Defective oil pressure sensor
BMW DTC P1583 seriousness
Ignoring DTC P1583 on a BMW can lead to serious engine damage due to inadequate lubrication. It is important to address this issue promptly to prevent potential engine failure.
How to diagnose DTC P1583 on BMW
To diagnose DTC P1583 on a BMW, a mechanic would typically perform the following steps:
- Use a diagnostic scanner to retrieve the fault code and freeze frame data
- Inspect the engine oil level and pressure
- Check the wiring and connectors in the oil pump control circuit
- Test the oil pump control module and oil pressure sensor for proper operation
How to fix DTC P1583 on BMW
To fix DTC P1583 on a BMW, the following steps may be taken:
- Repair or replace any damaged wiring or connectors in the oil pump control circuit
- Replace the faulty engine oil pump control module
- Ensure the engine oil level and pressure are at the correct levels
- Replace the defective oil pressure sensor if necessary
How to erase DTC P1583 on BMW
After fixing the underlying issue causing DTC P1583 on a BMW, the fault code can be erased using a diagnostic scanner. This will clear the code from the ECM’s memory and turn off the Check Engine Light.