P2141 – BMW DTC

BMW DTC P2141 – EGR Throttle Control Circuit ‘A’ Low

DTC P2141 meaning on BMW

DTC P2141 on a BMW indicates a fault in the EGR (Exhaust Gas Recirculation) Throttle Control Circuit ‘A’, specifically signaling a low voltage condition. This fault code is typically triggered when the Engine Control Module (ECM) detects that the voltage in the EGR throttle control circuit is below the specified range.

BMW DTC P2141 symptoms

Symptoms associated with DTC P2141 on a BMW may include:

• Check Engine Light (MIL) illuminated on the dashboard
• Reduced engine performance
• Engine stalling or rough idling
• Increased fuel consumption

BMW DTC P2141 causes

The common causes of DTC P2141 on a BMW include:

• Faulty EGR throttle control circuit ‘A’
• Wiring issues such as shorts or open circuits in the EGR system
• Defective EGR throttle control actuator
• Issues with the Engine Control Module (ECM)

BMW DTC P2141 seriousness

While DTC P2141 may not always result in immediate drivability issues, it is important to address this fault code promptly to prevent potential engine performance problems and to ensure emissions compliance.

How to diagnose DTC P2141 on BMW

To diagnose DTC P2141 on a BMW, a mechanic would typically perform the following steps:

1. Use a diagnostic scanner to retrieve the fault code and related data
2. Inspect the EGR throttle control circuit ‘A’ for any visible damage or loose connections
3. Test the EGR throttle control actuator for proper operation
4. Check the wiring harness for continuity and shorts
5. Verify the ECM functionality and communication with the EGR system

How to fix DTC P2141 on BMW

To fix DTC P2141 on a BMW, the following steps may be taken:

1. Repair or replace any damaged wiring in the EGR throttle control circuit
2. Replace the EGR throttle control actuator if found to be faulty
3. Reset the fault codes and perform a test drive to verify the repair

How to erase DTC P2141 on BMW

To erase DTC P2141 on a BMW, you can use a diagnostic scanner to clear the fault code from the ECM’s memory. After the repair has been completed, it is important to reset the fault code and ensure that the issue has been resolved before driving the vehicle.