Ford DTC P1124 – Throttle Position Sensor out of Self-Test Range
DTC P1124 meaning on Ford
DTC P1124 for Ford indicates that the Throttle Position Sensor (TPS) is out of the self-test range. The TPS is a crucial component that monitors the position of the throttle valve and sends signals to the engine control module to adjust fuel delivery and ignition timing.
Ford DTC P1124 symptoms
Symptoms of DTC P1124 on a Ford vehicle may include:
- Check Engine Light (CEL) illuminated
- Engine may hesitate or stumble during acceleration
- Reduced engine power
- Potential rough idling
Ford DTC P1124 causes
Common causes of DTC P1124 on a Ford vehicle include:
- Faulty Throttle Position Sensor (TPS)
- Wiring or connector issues in the TPS circuit
- Carbon buildup on the throttle body
- Incorrect TPS calibration
Ford DTC P1124 seriousness
DTC P1124 should not be ignored as it can lead to drivability issues and potential safety concerns. It is recommended to address this issue promptly to ensure proper engine performance and efficiency.
How to diagnose DTC P1124 on Ford
To diagnose DTC P1124 on a Ford vehicle, you can:
- Use a diagnostic scanner to retrieve the trouble codes
- Inspect the TPS wiring and connectors for any damage or corrosion
- Check the TPS voltage readings with a multimeter
- Clean the throttle body to remove any carbon buildup
How to fix DTC P1124 on Ford
To fix DTC P1124 on a Ford vehicle, you can:
- Replace the Throttle Position Sensor (TPS) if faulty
- Repair any damaged wiring or connectors in the TPS circuit
- Calibrate the TPS according to manufacturer specifications
- Clear the trouble codes and perform a test drive to verify the repair
How to erase DTC P1124 on Ford
To erase DTC P1124 on a Ford vehicle, you can:
- Use a diagnostic scanner to clear the trouble codes
- Disconnect the battery for a few minutes to reset the ECM
- Ensure the underlying issue causing the DTC has been addressed before clearing the code