P1196 – Hyundai DTC

Hyundai DTC P1196 – Electronic throttle system (ETS) – limp-home valve ON

DTC P1196 meaning on Hyundai

DTC P1196 on a Hyundai refers to an issue with the Electronic Throttle System (ETS) where the limp-home valve is stuck in the ON position. This means that the vehicle’s engine control module has detected a fault that is causing the throttle system to operate in a restricted mode to protect the engine.

Hyundai DTC P1196 symptoms

Symptoms of DTC P1196 on a Hyundai may include:

• Reduced engine power
• Engine stalling or hesitation
• Check Engine Light illuminated on the dashboard

Hyundai DTC P1196 causes

Common causes of DTC P1196 on a Hyundai include:

• Issues with the throttle position sensor
• Faulty electronic throttle control unit
• Wiring or connection problems in the throttle system

Hyundai DTC P1196 seriousness

DTC P1196 on a Hyundai should be addressed promptly as it can lead to drivability issues and potential engine damage if left unresolved. Driving with the limp-home valve activated can affect the vehicle’s performance and fuel efficiency.

How to diagnose DTC P1196 on Hyundai

To diagnose DTC P1196 on a Hyundai, a mechanic would typically:

1. Use a diagnostic scanner to retrieve the trouble codes stored in the engine control module
2. Inspect the throttle system components for any visible damage or wear
3. Test the throttle position sensor and electronic throttle control unit for proper operation
4. Check the wiring and connections in the throttle system for any faults

How to fix DTC P1196 on Hyundai

To fix DTC P1196 on a Hyundai, the following steps may be taken:

1. Replace the faulty throttle position sensor or electronic throttle control unit
2. Repair any damaged wiring or connections in the throttle system
3. Clean the throttle body and perform a throttle relearn procedure
4. Reset the engine control module to clear the trouble code

How to erase DTC P1196 on Hyundai

To erase DTC P1196 on a Hyundai, the trouble code can be cleared using a diagnostic scanner. After the underlying issue has been addressed and fixed, the code can be cleared to reset the engine control module and turn off the Check Engine Light.