B1356 – OBD-II DTC

OBD-II DTC B1356 – Ignition Run Circuit Open

DTC B1356 meaning

DTC B1356 refers to a diagnostic trouble code indicating an “Ignition Run Circuit Open.” This code is triggered when the vehicle’s onboard diagnostic system detects an issue with the ignition run circuit, which is essential for the proper operation of various electrical components in the vehicle. The ignition run circuit is responsible for supplying power to the engine control module (ECM) and other critical systems when the ignition is in the “run” position.

DTC B1356 symptoms

Common symptoms associated with DTC B1356 may include:

• Engine not starting or stalling
• Dashboard warning lights illuminated
• Loss of power to electrical components
• Intermittent or complete failure of the ignition system

DTC B1356 causes

Several factors can lead to the triggering of DTC B1356, including:

• Open or shorted wiring in the ignition run circuit
• Faulty ignition switch
• Defective engine control module (ECM)
• Corroded or loose electrical connections
• Blown fuses related to the ignition system

DTC B1356 seriousness

DTC B1356 is considered a serious issue as it can prevent the vehicle from starting or cause it to stall unexpectedly. This can lead to dangerous situations, especially if it occurs while driving. It is important to address this code promptly to ensure the vehicle’s reliability and safety.

How to diagnose DTC B1356

To diagnose DTC B1356, follow these steps:

1. Use an OBD-II scanner to confirm the presence of the code.
2. Inspect the ignition run circuit wiring for any visible damage or disconnections.
3. Check the ignition switch for proper operation.
4. Test the electrical connections for corrosion or looseness.
5. Examine fuses related to the ignition system for any blown fuses.
6. Perform a continuity test on the ignition run circuit.
7. If necessary, test the engine control module (ECM) for faults.

How to fix DTC B1356 step-by-step instructions

To fix DTC B1356, follow these steps:

1. Repair or replace any damaged wiring in the ignition run circuit.
2. Replace a faulty ignition switch if it is not functioning correctly.
3. Clean or tighten any corroded or loose electrical connections.
4. Replace any blown fuses related to the ignition system.
5. If the ECM is found to be defective, replace it with a new unit.
6. Clear the DTC using an OBD-II scanner.
7. Test drive the vehicle to ensure the issue is resolved and the code does not return.

How to erase DTC B1356

To erase DTC B1356, follow these steps:

1. Connect an OBD-II scanner to the vehicle’s diagnostic port.
2. Turn the ignition key to the “on” position without starting the engine.
3. Access the scanner’s menu and select the option to clear or erase trouble codes.
4. Confirm the action and wait for the scanner to complete the process.
5. Disconnect the scanner and start the vehicle to check if the code reappears.