P0208 – OBD-II DTC

OBD-II DTC P0208 – Injector Circuit Malfunction – Cylinder 7

DTC P0208 meaning

DTC P0208 refers to a malfunction in the injector circuit for cylinder 7. This code indicates that the Engine Control Module (ECM) has detected an issue with the electrical circuit that controls the fuel injector for this specific cylinder. The injector may not be functioning properly, leading to potential engine performance issues.

DTC P0208 symptoms

Common symptoms associated with DTC P0208 may include:

• Engine misfire or rough idle
• Decreased engine performance
• Increased fuel consumption
• Check Engine Light (CEL) illuminated
• Difficulty starting the engine

DTC P0208 causes

Several factors can lead to the occurrence of DTC P0208, including:

• Faulty fuel injector for cylinder 7
• Open or short circuit in the injector wiring
• Defective ECM or poor ECM connections
• Corroded or damaged connectors
• Faulty fuel injector driver circuit

DTC P0208 seriousness

DTC P0208 is considered a serious issue as it can lead to engine performance problems. If left unaddressed, it may result in:

• Increased emissions
• Potential engine damage
• Reduced fuel efficiency
• Failure to pass emissions tests

How to diagnose DTC P0208

To diagnose DTC P0208, follow these steps:

1. Use an OBD-II scanner to confirm the presence of the P0208 code.
2. Inspect the wiring and connectors for cylinder 7’s injector for any visible damage or corrosion.
3. Check the resistance of the injector using a multimeter to ensure it is within specifications.
4. Test the voltage and ground at the injector connector while the engine is running.
5. Examine the ECM for any fault codes related to the injector circuit.

How to fix DTC P0208 step-by-step instructions

To fix DTC P0208, follow these steps:

1. Repair or replace any damaged wiring or connectors associated with the injector circuit.
2. If the injector is faulty, replace it with a new one.
3. Ensure that the ECM is functioning correctly and reprogram if necessary.
4. Clear any fault codes using an OBD-II scanner.
5. Test drive the vehicle to ensure the issue is resolved and the Check Engine Light does not reappear.

How to erase DTC P0208

To erase DTC P0208, follow these steps:

1. Connect an OBD-II scanner to the vehicle’s diagnostic port.
2. Turn on the ignition without starting the engine.
3. Navigate to the “Erase Codes” or “Clear Codes” option on the scanner.
4. Confirm the action to clear the codes.
5. Disconnect the scanner and start the engine to verify that the Check Engine Light is off.

Recommended tools for OBD-II diagnostics

Explore our expert picks: The Best OBD2 Scanners for 2025

Easy-to-use Multimeter for reliable diagnostics: AstroAI Auto-ranging Multimeter

Some of the links on this page may be affiliate links, which means we may earn a small commission if you make a purchase. This helps us keep our DTC database up to date and provide valuable content for free. We only recommend products that we have tested and believe to be the best in their class.