P1210 – OBD-II DTC

OBD-II DTC P1210 – Injector Circuit Open / Shorted – Cylinder #3

DTC P1210 meaning

DTC P1210 indicates an issue with the injector circuit for cylinder #3. This code is triggered when the Engine Control Module (ECM) detects an open or shorted condition in the injector circuit, which can prevent the injector from functioning properly. The injector is responsible for delivering fuel to the engine, and any malfunction can lead to performance issues.

DTC P1210 symptoms

Common symptoms associated with DTC P1210 may include:

• Engine misfire or rough idle
• Decreased engine performance
• Increased fuel consumption
• Check Engine Light (CEL) illuminated
• Difficulty starting the engine

DTC P1210 causes

Several factors can lead to the triggering of DTC P1210, including:

• Open circuit in the injector wiring
• Short circuit in the injector wiring
• Faulty fuel injector for cylinder #3
• Defective ECM
• Corroded or loose electrical connectors

DTC P1210 seriousness

DTC P1210 is considered a serious issue as it directly affects the engine’s fuel delivery system. If left unaddressed, it can lead to:

• Severe engine performance issues
• Potential engine damage
• Increased emissions
• Failure to pass emissions tests

How to diagnose DTC P1210

To diagnose DTC P1210, follow these steps:

1. Use an OBD-II scanner to confirm the DTC and check for any additional codes.
2. Inspect the wiring and connectors for cylinder #3 injector for any visible damage or corrosion.
3. Test the injector resistance using a multimeter to ensure it is within specifications.
4. Check for continuity in the injector circuit to identify any open or shorted conditions.
5. Test the ECM output to the injector to ensure it is functioning correctly.

How to fix DTC P1210 step-by-step instructions

To fix DTC P1210, follow these steps:

1. Repair or replace any damaged wiring or connectors in the injector circuit.
2. If the injector is faulty, replace the injector for cylinder #3.
3. Ensure all connections are secure and free of corrosion.
4. If the ECM is determined to be faulty, replace or reprogram the ECM as necessary.
5. Clear the DTC using an OBD-II scanner and test drive the vehicle to ensure the issue is resolved.

How to erase DTC P1210

To erase DTC P1210, follow these steps:

1. Connect an OBD-II scanner to the vehicle’s diagnostic port.
2. Turn the ignition key to the “On” position without starting the engine.
3. Navigate to the “Erase Codes” or “Clear DTCs” option on the scanner.
4. Confirm the action to clear the codes.
5. Disconnect the scanner and start the engine to verify that the code does not reappear.

Recommended tools for OBD-II diagnostics

Explore our expert picks: The Best OBD2 Scanners for 2025

Easy-to-use Multimeter for reliable diagnostics: AstroAI Auto-ranging Multimeter

Some of the links on this page may be affiliate links, which means we may earn a small commission if you make a purchase. This helps us keep our DTC database up to date and provide valuable content for free. We only recommend products that we have tested and believe to be the best in their class.