P1305 – OBD-II DTC

OBD-II DTC P1305 – Boost Calibration Fault

DTC P1305 meaning

DTC P1305 refers to a “Boost Calibration Fault” in the vehicle’s engine management system. This code indicates that the engine control module (ECM) has detected an issue with the boost pressure calibration, which is crucial for optimal engine performance. The boost pressure is typically managed by a turbocharger or supercharger, and any discrepancies can lead to performance issues or increased emissions.

DTC P1305 symptoms

Common symptoms associated with DTC P1305 may include:

• Reduced engine power or performance
• Increased fuel consumption
• Check Engine Light (CEL) illuminated
• Unusual engine noises
• Engine stalling or misfiring

DTC P1305 causes

Several factors can lead to the triggering of DTC P1305, including:

• Faulty boost pressure sensor
• Issues with the turbocharger or supercharger
• Vacuum leaks in the intake system
• Faulty wiring or connectors related to the boost control system
• Software issues in the ECM

DTC P1305 seriousness

The seriousness of DTC P1305 can vary depending on the underlying cause. While it may not immediately lead to catastrophic engine failure, it can result in:

• Decreased engine efficiency
• Increased emissions
• Potential long-term damage if left unaddressed

It is advisable to diagnose and repair the issue promptly to maintain vehicle performance and compliance with emissions regulations.

How to diagnose DTC P1305

To diagnose DTC P1305, follow these steps:

1. Use an OBD-II scanner to confirm the presence of the DTC.
2. Check for any additional trouble codes that may provide more context.
3. Inspect the boost pressure sensor and its wiring for damage or disconnections.
4. Test the boost pressure sensor using a multimeter to ensure it is functioning correctly.
5. Examine the turbocharger or supercharger for any mechanical issues.
6. Look for vacuum leaks in the intake system.
7. Review the ECM software version and update if necessary.

How to fix DTC P1305 step-by-step instructions

To fix DTC P1305, follow these step-by-step instructions:

1. Clear the DTC using an OBD-II scanner.
2. Inspect and repair any damaged wiring or connectors related to the boost pressure sensor.
3. Replace the boost pressure sensor if it is found to be faulty.
4. Check and repair any vacuum leaks in the intake system.
5. Inspect the turbocharger or supercharger for proper operation and repair as needed.
6. Reprogram or update the ECM if software issues are suspected.
7. After repairs, clear the DTC again and take the vehicle for a test drive to ensure the issue is resolved.

How to erase DTC P1305

To erase DTC P1305, follow these steps:

1. Connect an OBD-II scanner to the vehicle’s diagnostic port.
2. Turn on the ignition without starting the engine.
3. Access the trouble codes menu on the scanner.
4. Select the option to clear or erase trouble codes.
5. Confirm the action and wait for the scanner to indicate that the codes have been cleared.
6. Disconnect the scanner and start the engine to verify that the Check Engine Light is off.

Recommended tools for OBD-II diagnostics

Explore our expert picks: The Best OBD2 Scanners for 2025

Easy-to-use Multimeter for reliable diagnostics: AstroAI Auto-ranging Multimeter

Some of the links on this page may be affiliate links, which means we may earn a small commission if you make a purchase. This helps us keep our DTC database up to date and provide valuable content for free. We only recommend products that we have tested and believe to be the best in their class.